Liquidation price on Bitunix, explained with today's ZEC swing
why the mark price (not the last trade) triggers it, how leverage drags the line toward your entry, and the three habits that keep you away from it
Key takeaway
$ZEC.USDT gave a live lesson in liquidation math today. On Bitunix it opened the 24-hour window at 930.33, traded as high as 938.59 and as low as 800.99, and sat at a mark of 858.56 at 7:35 PM ET on Saturday (Bitunix public API). High to low, that is a 14.7% drop.

Bitunix Academy's guide to liquidation price explains why moves like that wipe out leveraged positions long before they look dramatic on a daily chart.
What the liquidation price is
It is the price at which the exchange closes your leveraged position for you, because your collateral no longer covers the minimum margin requirement. There is no negotiation; the system does it automatically. Bitunix Academy's framing is blunt: you can get the direction right and still lose the margin if you ignore this one number.
Two kinds of margin
Initial margin is what you put down to open. At 10x leverage you control roughly ten times your margin in exposure, before fees and rules. Maintenance margin is the floor you must keep to hold the position. It is not always a single fixed rate; it often rises with position size through risk tiers. When your margin balance falls to that floor, liquidation starts.
The gotcha: mark price, not last price
Liquidation triggers on the mark price in most setups, not the last traded price. That protects you from a single manipulative wick on one order book, but it also means the trigger can be hit even if the last price never printed your level. Tonight the two were close: $ZEC.USDT mark 858.56 against last 858.50, $BTC.USDT mark 63,703.4 against last 63,703.3 and index 63,723.7. On a fast candle they separate, and the mark is the one that counts.
How close leverage puts the line
Bitunix Academy gives an illustrative example, not a formula for any one exchange: a 10x long on Bitcoin at 100,000 might liquidate around 90,500, while a 50x long at the same entry could liquidate as close as 98,200. The simplified relationship for a long is liquidation price roughly equals entry minus the margin buffer divided by position size. Higher leverage, higher maintenance requirements and fees, including funding and closing fees, all pull it closer.
Run today's $ZEC.USDT range through the simplest version of that logic. At 10x, your initial margin is 10% of the position, so a 10% adverse move consumes all of it before maintenance margin and fees are even counted. A 14.7% high-to-low swing goes straight through that. At 3x, margin is about 33% of the position, and the same swing leaves room. That is our arithmetic on round leverage levels, not a Bitunix calculation, but it is why leverage choice matters more than entry timing on days like this.
Funding keeps nibbling too. At the time of the reading, Bitunix showed $ZEC.USDT funding at +0.00564% per 8 hours (cap plus or minus 2%), $SOL.USDT at +0.013903% per 8 hours and $ETH.USDT at -0.004428% per 8 hours. Small per period, but on an isolated position every payment is drawn from the same margin that keeps liquidation away.
Three ways to keep distance from the line
- Use lower leverage. Bitunix Academy puts it plainly: at 3x to 5x you can survive ordinary volatility; at 25x to 50x you are asking to be right immediately.
- Use a stop-loss you choose. Liquidation is the worst version of closing: forced, often during fast moves, with fees and no flexibility. Put the stop where your trade idea is wrong, not just above liquidation. A stop hugging the liquidation price still leaves the engine to save you in a fast market.
- Add margin only if the thesis still holds. Extra collateral pushes liquidation further away, but topping up just to avoid admitting a mistake is how small losses become large ones.
What Bitunix shows you before and during a trade
Bitunix displays an Estimated Liquidation Price, the level where the position would close for insufficient margin, and the app shows it when placing orders, so you can check it before you commit. Bitunix also documents that liquidation behaviour depends on risk tiers, and that before full forced liquidation it can cancel open orders to release margin and, in some cases, partially reduce a position. Larger positions and higher leverage can land you in a tier with a higher maintenance rate.
A pre-trade routine
- Read the Estimated Liquidation Price on the order panel before every open.
- Recheck it after any change to leverage or size, and after adding margin.
- Compare its distance from entry with the recent range of the pair: today, $XRP.USDT and $SOL.USDT also moved several percent.
- Place the stop first, then size the position so the stop loss is an amount you accept.
If the liquidation line sits inside the pair's normal daily range, the position is too big or the leverage too high. Fix that before the market does it for you.
FAQ
Can I be liquidated if the last price never touches my level?
Yes. Liquidation usually triggers on the mark price, which can reach your level even when the last trade does not.
Does adding margin move my liquidation price?
Yes. Extra collateral increases the buffer and moves liquidation further from the current price.
Where can I see my liquidation price on Bitunix?
Bitunix shows an Estimated Liquidation Price, including on the order panel when placing orders.