Home / Learn / USDT Networks

USDT Networks Explained: TRC20 vs ERC20 vs BEP20

By Updated

Short answer

TRC20, ERC20 and BEP20 USDT are the same stablecoin issued on three separate blockchains: Tron, Ethereum and BNB Smart Chain. They are not interchangeable. The network you withdraw on must match the network of the deposit address you send to. If they don't match, the deposit is not credited, and getting it back depends on the receiving exchange.

Checked

We checked each exchange's official pages on Nov 3, 2026 (9:20–9:30 AM ET). Where an exchange gives no figure, we say "not stated by the exchange". Binance's network-by-network withdrawal reopening the same week shows why this matters; the case study is further down.

Same USDT, different blockchains

USDT is a token, and a token lives on a specific blockchain. "USDT-TRC20" is USDT on Tron, "USDT-ERC20" is USDT on Ethereum, and "USDT-BEP20" is USDT on BNB Smart Chain. Each is a balance in that chain's ledger only. A transfer on Tron is never seen by Ethereum, and the reverse is also true.

That's why exchanges ask for a network as well as a coin. BloFin's FAQ says the networks must match: "if you select USDT-ERC20 as the deposit network, the withdrawal network should also be USDT-ERC20". Bitbase's help center gives the same example: if you deposit USDT via Ethereum, select ERC-20 and make sure the sending platform also uses ERC-20. It adds that the same coin "may be supported on multiple networks, but these networks are not necessarily interchangeable."

The networks differ in practice:

  • Speed. BloFin's FAQ (Jul 28, 2026) says TRC20 deposits usually confirm in "1–5 minutes" and ERC20 in "10–30 minutes".
  • Cost. Withdrawal fees are set per network by each exchange. They are compared in the table below.
  • Address format. Tron addresses start with "T". Ethereum and BNB Smart Chain addresses both start with "0x" and look identical, which is how ERC20 and BEP20 get mixed up.

For a wider explainer on chains and gas, see networks and gas.

How to choose a USDT network

Three questions decide it:

  1. Does the receiving side support it? If the receiving deposit page doesn't list the network, don't use it.
  2. What does the sending side charge? On our partners' published tables, BEP20 is the cheapest of the three. TRC20 vs ERC20 depends on the exchange.
  3. How much are you moving? BloFin's FAQ says TRC20 "works better for small deposits/withdrawals" and ERC20 "is more efficient for large deposits/withdrawals."

USDT networks, minimums and fees on BloFin, Bitunix and Bitbase

Figures as published on Nov 3, 2026 (checked 9:20–9:30 AM ET). All amounts are in USDT. Each exchange says the fee shown on its withdraw page at the time of your transaction is the one that applies.

Exchange Networks for USDT (published) Min deposit Min withdrawal Withdrawal fee Source
BloFin TRC20, ERC20, BEP20 Not stated by the exchange (shown on the Deposit page) Not stated by the exchange (shown on the Withdraw page) Not stated by the exchange BloFin FAQ "Deposit Not Credited" (Jul 28, 2026) and FAQ on minimum withdrawals (May 29, 2026)
Bitunix TRC20, ERC20, BEP20 and others, including Solana, TON, Arbitrum, Polygon and Base 0.1 on TRC20, ERC20 and BEP20 2 on TRC20, ERC20 and BEP20 TRC20: 1 · ERC20: 2 · BEP20: 0.5 Bitunix "Crypto Withdrawal Fees & Limits" (updated Aug 13, 2026)
Bitbase TRC20, ERC20, BEP20, Polygon PoS, TON, AVAX C-Chain, Arbitrum, Solana Not stated by the exchange (shown on the deposit page) TRC20: 3 · ERC20: 10 · BEP20: 5 TRC20: 1 · ERC20: 0.39 · BEP20: 0.01 (deposits: free) bitbase.com/rate, "Deposit & Withdraw" tab

Notes:

  • BloFin doesn't publish a per-network fee or minimum table. Its FAQ says minimums appear on the Deposit and Withdraw pages after you pick a coin and network.
  • Bitunix says it "does not collect extra deposit fees".
  • Bitbase's help center says the minimum deposit is "specified on the deposit page". The withdrawal figures above come from Bitbase's own fee page. For the full deposit walkthrough, see our Bitbase sign-up, deposit and withdrawal guide. Trading fees for all partners are on our fees page.

Before you hit withdraw: a 5-step network check

  1. Match the network on both sides. Read the network name on the receiving deposit page and on the sending withdraw page. Confirm they are the same chain (TRC20 = Tron, ERC20 = Ethereum, BEP20 = BNB Smart Chain) before you paste anything.
  2. Copy-paste the address, then check the first and last characters. Never type an address by hand. After pasting, compare the first four and last four characters with the source. Clipboard malware swaps addresses.
  3. Check for a memo or tag. If the deposit page shows a memo or tag field, fill it in. Bitbase warns that "omitting a required Memo/Tag may prevent your deposit from being credited".
  4. Clear the minimum deposit. On all three partners, a deposit below the minimum is not credited. BloFin calls such deposits "generally non-recoverable", and Bitunix says they "cannot be refunded". The minimum is set by the receiving exchange, and the withdrawal fee is taken before the funds arrive, so check what will land, not just what you send.
  5. Send a small test first. For a new address or a new network, send a small amount and wait until it's credited. It costs one extra network fee. Then send the rest.

Sent on the wrong network? What happens next

A confirmed blockchain transaction can't be cancelled. Bitunix says "blockchain transactions cannot be reversed", and Bitbase says they "generally cannot be canceled or reversed once broadcast". What happens next depends on the case you're in. Bitbase's blog splits mistakes into five cases:

  1. Right network, wrong recipient. The funds now sit at someone else's address. Getting them back depends on that person, if you can identify them.
  2. Right address, wrong network, and you hold the key. If you sent from your own wallet to your own address on the wrong EVM chain (say BEP20 instead of ERC20), the tokens are on the chain you actually used. Adding that network to your wallet, and holding its gas coin, usually lets you see and move them.
  3. Wrong network to an exchange deposit address. You don't hold that key, so recovery depends on whether the exchange can and will run a manual retrieval. Bitbase's blog calls this "policy, not physics".
  4. Sent to a smart contract, for example the token's own contract address. Bitunix calls deposits to a smart contract address "impossible to recover". The exception is a contract that has a rescue function built in.
  5. An address nobody controls. That's final.

Case 3 is the usual wrong-network mistake on an exchange. Here is what each partner says.

How to request a recovery on each partner

None of the three promises recovery, and neither do we. Each describes its own process, which is set out below.

BloFin. If you choose TRC20 on BloFin but send on ERC20, the funds "will not be credited and may be unrecoverable", BloFin's FAQ says. Sending on a network BloFin doesn't support "may result in permanent loss of funds". To ask for help, open a "Submit a Request" ticket with: the TXID, the token and network used, the amount, the time of the transfer, and screenshots of the withdrawal from the sending platform. BloFin's FAQ doesn't state a fee or a timeline.

Bitunix. For a wrong address or wrong network (its example is ERC20 sent to a "BSC20", meaning BEP20, address), Bitunix says to "submit a request in time" and that "a certain handling fee may be charged for manual processing". The same applies to a wrong token or a wrong memo/tag. For unsupported tokens, it asks for your email and UID, the token, the amount, the TXID and the deposit address, and says "an extra service fee may be charged". Bitunix doesn't publish the amount of these fees.

Bitbase. Bitbase's help center says a wrong network "may prevent your deposit from being credited and could result in asset loss". For a deposit that is confirmed on-chain but not credited, contact official support with your UID, the coin and amount, the network, the TxID, the deposit time and the deposit address. Bitbase's Terms of Use (updated Oct 28, 2026) also state: "Bitbase will not reverse or recover assets sent to an incorrect wallet address." The help center doesn't describe a separate wrong-network recovery process.

What to have ready for any ticket: your UID, the TXID, the amount, the network you used, the network you intended, the deposit address, and a screenshot of the transaction on a block explorer.

Recovery scams: the second loss

People who lose crypto get targeted again. Bitbase's blog cites the FBI's IC3: private recovery companies cannot issue seizure orders, and law enforcement doesn't charge victims a fee. Bitunix says: "Do not trust third parties who claim to recover your assets via private messages." BloFin's Academy also warns against guaranteed-recovery services and seed-phrase requests. Never share a seed phrase, never pay a third party up front, and only open tickets through the exchange's own help center.

Binance case study: withdrawals reopened one network at a time

Binance is not a LiquidityFlow partner; these facts come from its official announcements. On Nov 1, 2026, Binance's "Recovery Update #4" restarted withdrawals in phases, listing USDT separately on Ethereum, BSC, Tron, Solana, TON, Polygon, AVAX C-Chain, Arbitrum and Optimism. Its "Recovery Update #6" reopened more assets from 04:00 UTC on Nov 3 (11:00 PM ET on Nov 2), warning that "Not all listed assets will become available at once" because it was restoring "each network-asset pair" after security checks, while deposits "remain open and are not affected".

The lesson: "USDT withdrawals are open" is incomplete. What matters is whether USDT on your network is open on the sending side and supported on the receiving side. For how we check an exchange's safety record, see is BloFin legit? and is Bitunix legit?. To check what an exchange holds, see proof of reserves.

Questions

Is TRC20 cheaper than ERC20?
It depends on the exchange. BloFin's FAQ says TRC20 is "faster and cheaper". Bitunix charges 1 USDT on TRC20 and 2 USDT on ERC20. Bitbase's fee page lists 1 USDT on TRC20 and 0.39 USDT on ERC20. On both of those tables, BEP20 is the lowest: 0.5 on Bitunix and 0.01 on Bitbase. Always check the fee on the withdraw page.
Can I send ERC20 USDT to a BEP20 address?
No. They are different chains, even though both addresses start with "0x". The receiving exchange won't credit it on the network it expects. Bitunix uses this exact case as its wrong-network example, and BloFin and Bitbase warn that a mismatch can mean losing the funds.
Is USDT sent to the wrong network lost forever?
Not always, but there is no guarantee. If you hold the key to the destination address, you can usually reach the funds on the chain you used. If it went to an exchange deposit address, the exchange decides. Bitunix may run a manual recovery for a handling fee. BloFin says such funds "may be unrecoverable", and Bitbase's Terms say it "will not reverse or recover assets sent to an incorrect wallet address."
How long does a recovery take?
Not stated by the exchange: none of BloFin, Bitunix or Bitbase publishes a recovery timeline. BloFin's general Academy guide says timelines across the industry "range from days to weeks". It is not a BloFin-specific commitment.
Can I withdraw from Bitunix on TRC20?
Yes. Bitunix's fee page lists USDT on Tron (TRC-20) with a 2 USDT minimum withdrawal and a 1 USDT fee (page updated Aug 13, 2026). Bitunix says the fee on the withdrawal page at the time of your transaction is the one that applies.

Not investment advice. This page is for education only. Exchange fees, networks and policies change, so check the exchange's own pages before you send.

Sources

Read our methodology and disclaimer.

Partner exchanges